--NEW VERSION--Complete kit springer BM20/50 Height 50mm

New version with springer retaining clip and cap made of FDA silicone for easier assembly

1-Insert the ends of the filter into the fitting leaving a space of about 5-7 mm between the terminals

2-Insert the paper clip up to the stop

3-Insert the silicone cap

The Springer filter is longer 150cm. Everyone will have to cut it to the right length through a normal cutter.

In attachments the instructions for mounting and cut springer

In attacchments the instructions for a correct use of springer

The filter Springer length 150 cm included

With this special joint is possible insert a Springer in a Braumeister BM20 without having to make any changes to your Braumeister and without disturbing the malt pipe.

Thanks to this joint besides getting an optimal filtration of coarse particles which escape the basket or malt pipe you have the great advantage to extract ALL the wort.

Output height at which you place the faucet makes 4.8 liters of must not escape if not tilting the BM. The tilt though because the exit of the rough parts, and defeats the deposit.

Thanks to how it's built the special fitting ALL the wort be sucked without tilting the tank.

The special siding is constructed completely in stainless steel AISI 316

The following photo is relative to all the pieces that make up the join, spare o-rings and gasket included

The design of this joint and the fact that it can be removed makes its cleaning and sanitising very easy.

All the gaskets are Food Grade Certified (including the red O-ring and top gasket) so they won’t release noxious substances and they are effective at  200 °C (set with quick peaks of 250 °C)

Assembly instructions    

How do I use